5/16/2023 0 Comments Configure fstab mediacentral![]() Reboot and see that your drive gets automatically mounted now. PySDM assistant for automounting NTFS partition: PySDM assistant settings for automounting EXT4 partition: ![]() Now run the Storage Device Manager and select your preferred partition, click "Assistant": Nothing should go wrong, but just in case, backup the fstab conf: sudo cp /etc/fstab /etc/fstab.old Sudo apt-get install pysdm(Ubuntu) or sudo yum install pysdm(Fedora) The tutorial here will do basically the same as other answers in this thread suggest to do, but the tool will accomplish it with a couple of clicks and no need to enter configurations manually into fstab config file. This web page has a lot of useful info on fstabįor those lazy and cautious ones who want to use a simple and self-explanatory GUI there is a tool called Storage Device Manager (pysdm). Then on the next reboot it will auto mount. dev/sdb1 /home/yourname/mydata ext4 defaults 0 1 This assumes the partition is formatted as ext4 as per mkfs above #device mountpoint fstype options dump fsck You need to add it to /etc/fstab use your favourite text editorīe careful with this file as it can quite easily cause your system not to boot.Īdd a line for the drive, the format would look like this. Okay now you have a partition, now you need a filesystem. Then press 1 and press Enter (creates it as the 1st partition)įinally, press W (this will write any changes to disk) Press P and press Enter (makes a primary partition) Press N and press Enter (creates a new partition) Press O and press Enter (creates a new table) WARNING: THIS WILL DESTROY ANY DATA ON YOUR TARGET DISK I am assuming this is the disk you want to mount. Units = cylinders of 16002 * 512 = 8193024 bytesįirst of all your /dev/sdb isn't partitioned. I/O size (minimum/optimal): 512 bytes / 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes This is the output from running sudo fdisk -l on my system: Disk /dev/sda: 500.1 GB, 500107862016 bytesĢ55 heads, 63 sectors/track, 60801 cylinders I want to have the machine automatically mount the device on startup/reboot. I have manually mounted the drive as /mydata. I used System -> Administration -> Disk Utils to format the disk (ext4 file type) - but did not create a partition (is this advisable?). (But of course, if you are mounting a non-empty EXT filesystem with existing files belonging to other users, you might need this option.I have recently installed a new hard drive to my Ubuntu 10.0.4 box. I have tested this without using the -t option and it works fine. As we work as normal users in the /media/foo directory, we will be owning all the sub-directories and files we create. The +t option "prevents unprivileged users from removing or renaming a file in the directory unless they own the file or the directory". One of the comments in the accepted answer suggests adding a +t to the chmod command. The directory /media/foo is just a simple Linux directory, and directory permissions are persistent and need not be set every time on boot. We are modifying the permissions of the mount point /media/foo and not the permissions of the device /dev/sda8. ![]() ![]() Running the chmod command every time on start up is unnecessary. They are mount options for the FAT filesystem, as you can very well see here: man mount. The second most-voted answer suggests doing this using the umask option (and from some other sources even uid/ guid options) but I believe EXT filesystems do not suppport these options. While it might seem inelegant, because ideally we would want to set the right permissions in Fstab itself. The accepted answer is the correct answer: chmod 777 /media/foo. I want to capture everything about this in a single answer, so here it is: ![]()
0 Comments
Leave a Reply. |